Calmar Corporation
Thermal insulation · Open- and closed-cell SPF

Spray Foam Insulation

Thermal performance starts with the right system.

Established 1944 · Licensed in Louisiana, Mississippi and Alabama.

Caesars Superdome, New Orleans
Caesars Superdome, New Orleans
Open-cell and closed-cell

The right material for the job

Open cell and closed cell each do a job. The choice comes down to vapor control, water exposure, rigidity, and what the code calls for.

Open-cell foam is a great value with excellent air sealing. It is a natural fit for interior walls, ceilings and floors, where it stays dry. It is softer and vapor permeable, so it is not used where it might see water.

Closed-cell foam is denser and rigid, and it can stop vapor drive. That is why it holds up on exterior walls, below grade, and in places exposed to moisture.

Open-cellClosed-cell
DensityAbout 0.5 lb/ft³About 2 lb/ft³
R-value per inchAbout R-3.6–4.5About R-6–7

A Calmar example is the 2009 remodel of Caesars Superdome in New Orleans. After the exterior cladding and fiberglass insulation came off, Calmar sprayed closed-cell foam across the entire exterior walls — more than 400,000 sq ft — and protected it with polyurea. That gave the building high R-value, added rigidity, and a secondary drainage plane for water.

Typical densities and R-values from the Spray Polyurethane Foam Alliance and the U.S. Department of Energy.

Questions before a proposal

Can every foam provide the same air and vapor control?

No. Air and vapor control depend on the product and the assembly. Select the specified system and follow its requirements.

What should I send for a proposal?

Send project plans and specifications, including the required insulation system and performance requirements.

Plan your next project

Start with the right scope.

Send plans and specifications for a fireproofing or insulation scope review and proposal.

Send bid documents

504.464.6242